SEM 2 WEEK 9 AND WEEK 10

TITLE: Testing and troubleshoot the circuit

OBJECTIVE:
To test and analyze  the circuit

DISCUSSION/ANALYSIS: The driver circuit was tested using oscilloscope. The hall sensor output signal was displayed by using the movement of magnet. As the hall sensor get supply from the battery, it should working properly. Below is the result of output signal from hall sensor and the measurement setup.

 Fig 1: Measuremant setup

 Fig 2: Hall Effect Output Signal 

CONCLUSION:

I had successfully design and fabricate the circuit driver for 1-phase BLDC motor as I get the output result from the testing.