SEM2 WEEK 3

TITLE :

Design circuit diagram using Livewire software

OBJECTIVE :

To investigate the voltage output from the circuit before convert to PCB layout

CONTENT/PROCEDURE :

 I had a problem to simulate the driver circuit  because one of the component which is IR 2110 is not in the library. I went to see Mr. Suhairi to tell him about this problem. We discuss and agree to not doing the simulation and told me to proceed with the actual circuit on the breadboard to test it before doing it on the pcb.

 This figure show the 1 phase BLDC circuit driver using Livewire

CONCLUSION:

      The objective of this week is to understand and investigate the output circuit using  software and replace the components that not available for before convert into PCB layout.