SEM 2 WEEK 7

TITLE:
Correction on Chapter 1, Chapter 2 and Chapter 3 

OBJECTIVE:
To do a correction on the report draft

DISCUSSION/ANALYSIS:
This week, I focus on doing the correction the chapter stated above after my supervisor, Mr Suhairi give back the draft that I had submitted to him. Mr Suhairi told me about the mistake that I had done in my report. After discussed about the problem with Mr. Suhairi, I finally understand what need to be put in the that chapter. He also tell me to follow to standard format format at Unikl-BMI Final Year Project website.

CONCLUSION:

Redo chapter 1, 2 and 3 of the final year project and will submit to my supervisor in the following week.

SEM WEEK 6

TITLE:

 Continue Soldering the components

OBJECTIVE:

Put the components into PCB become actual circuit.

CONTENT/PROCEDURE :

 

I had misplace some of the component. The bridge (rectifier) is actually no need to attach in the circuit. Mr Suhairi  advised me to find another bride that suitable  with my circuit . I find it and  Rectifier 2W10 is most suitable. 

Here is the circuit that 90 percent done and ready to test. 

 

 

 CONCLUSION:

The driver circuit is ready to test with the motor.

SEM 2 WEEK 5

TITLE:

Soldering the components

OBJECTIVE:

Put the components into PCB become actual circuit.

CONTENT/PROCEDURE :

Before soldering process, I need to identify and study little bit about the components. Using the skill that I learn before, the process going smooth. If I make the wrong identification it will affect my circuit driver. I didn't cut the component's leg because need to show my adviser first to check the circuit and if  the mistake happens such as misplace the component's polarity, the correction can be done easily.

 CONCLUSION:

The progress for soldering process is about 70 percent done.